HP ZBook Fury 17 G7 - Hard Drive Cable Removal; Hard Drive Cable Removal (Authorized)

Remove the ngerprint reader module:
1. Release the ZIF connector (1) to which the ngerprint reader module cable is connected, and then
disconnect the ngerprint reader module cable from the system board.
2. Remove the Phillips M2.0 × 2.9 broad head screw (2) that secures the ngerprint reader module to the top
cover.
3. Remove the ngerprint reader module bracket (3).
The ngerprint reader module bracket is included in the Bracket Kit, spare part number M20094-001.
4. Remove the ngerprint reader module (4) and cable.
Reverse this procedure to install the ngerprint reader module and cable.
Hard drive cable
To remove the hard drive cable, use this procedure and illustration.
The hard drive cable is available in the Cable Kit, spare part number M20105-001.
Before removing the hard drive cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
72 Chapter 6 Removal and replacement procedures for authorized service provider parts ENWW