1. Prepare the computer for disassembly (Preparation for disassembly on page 66).
2. Remove the service cover (Service cover on page 40), and then remove the following components:
1. Battery (see Battery on page 41)
2. Solid-state drives 3 and 4 (see Solid-state drives 3 and 4 on page 42)
3. Solid-state drive carrier (see Solid-state drives 3 and 4 on page 42)
4. Hard drive (see Hard drive on page 44)
5. Keyboard (see Keyboard on page 54)
6. Bottom case (see Bottom case on page 66)
Remove the touchpad:
1. Detach the touchpad cable (1) from the top cover. (The touchpad cable is attached to the top cover with
double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
3. Remove the four Phillips M2.0 × 2.9 screws (3) that secure the touchpad to the top cover.
4. Remove the touchpad (4).
Reverse this procedure to install the touchpad.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
The NFC module cable is available in the Cable Kit, spare part number M20105-001.
ENWW Component replacement procedures 75
To Next Page
Loading...
