6. Insert a keyboard release tool or other thin, plastic tool through the KB release opening near the fan and
release the keyboard by pressing on its back.
7. Rest the open computer right side up with the front toward you.
8. Swing the top edge of the keyboard (1) up and forward until it rests upside down on the top cover.
9. Detach the backlight cable (2) from the top cover. (The backlight cable is attached to the top cover with
double-sided adhesive.)
10. Release the ZIF connector (3) to which the backlight cable is connected, and then disconnect the cable from
the connector.
11. Release the ZIF connector (4) to which the keyboard cable is connected, and then disconnect the cable
from the connector.
12. Release the pointing stick cable (5) through the opening in the top cover.
ENWW Component replacement procedures 57
To Next Page
Loading...
