HPE ProLiant BL460c Gen10

To replace the component, slide the uFF drive into the bay until it is firmly seated in the adapter and clicks into place.
More information
SFF flash adapter components and LED definitions
Removing and replacing DIMM bales
Removing the DIMM bales
The server blade has two DIMM bales.
Procedure
1.
Power down the server blade.
2.
Remove the server blade.
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel.
5.
If installed, remove the internal USB drive.
To locate the internal USB connector, see
System board components.
IMPORTANT: When removing a DIMM
bale, do not remove the following options when installed on the DIMM
bale:
• M.2 enablement option (left DIMM bale)
• HPE Smart Storage Battery (right DIMM bale)
6. If installed, remove the direct connect SATA cable from cable channel on the right air bale.
7. Remove one or more DIMM bales:
Removal and replacement procedures
46