HPE ProLiant BL460c Gen10

Procedure
1. Power down the server blade.
2. Remove the server blade.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel.
5. Remove the direct connect SATA cable.
To replace the component, reverse the removal procedure.
More information
Power down the server blade
Remove the server blade
Removing the access panel
Removing and replacing the mezzanine assembly
Removing the mezzanine assembly
Procedure
1. Power down the server blade.
2. Remove the server blade.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel.
5. Remove the mezzanine assembly.
Removal and replacement procedures
58