4. Install the server blade.
5. Power up the server blade.
More information
Power up the server blade
Replacing the access panel
Install the server blade
Removing and replacing the mezzanine card options
Removing the mezzanine card options
Prerequisites
A T-15 Torx screwdriver is required to perform this procedure.
Procedure
1. Power down the server blade.
2.
Remove the server blade.
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel.
5.
Remove the mezzanine assembly.
6.
Remove the mezzanine card from the mezzanine assembly.
More information
Power down the server blade
Remove the server blade
Removing the access panel
Removal and replacement procedures
60
To Next Page
Loading...
