HPE ProLiant BL460c Gen10

7. Place the server blade on a flat, level work surface.
IMPORTANT: Install all components in the same configuration before installing the server blade.
8.
Install the front panel/drive cage assembly (Removing and replacing the front panel/drive cage assembly).
9.
Install all DIMM bales (Removing the DIMM bales).
10.
Install the internal USB drive.
To locate the internal USB connector, see
System board components.
11.
Install the storage controller or NVMe pass-through board or connect the direct connect SATA cable (Removing a
storage controller or NVMe pass-through board).
12.
Install the mezzanine assembly (
Replacing the mezzanine assembly).
13.
Install the drives and drive blanks (Removing and replacing the drive bay options).
14.
Install the access panel.
15.
Install the server blade.
16.
Power up the server blade.
More information
Power up the server blade
Replacing the access panel
Install the server blade
Removal and replacement procedures
80