ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Remove the left chassis ear:
a. Remove left chassis ear screws (callouts 1).
Retain all screws for future use.
b. Detach the left chassis ear (callout 2).
To Next Page
Loading...
