Removing and replacing the PCIe5 x16 low-profile riserRemoving and replacing the PCIe5 x16 low-profile riser
Removing and replacing the PCIe5 x16 base riser from three-slot riser cageRemoving and replacing the PCIe5 x16 base riser from three-slot riser cage
Removing and replacing the free-height riserRemoving and replacing the free-height riser
Removing and replacing the stacking riserRemoving and replacing the stacking riser
Removing and replacing the PCIe5 x16 base riser from one-slot riser cageRemoving and replacing the PCIe5 x16 base riser from one-slot riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
To Next Page
Loading...
