4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. Remove the energy pack holder:
a. Pull and hold the release latch on the holder (callout 1).
b. Pull the holder towards the front panel to disengage from chassis (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the energy packRemoving and replacing the energy pack
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
To Next Page
Loading...
