4. Do one of the following:
a. Install the air baffle.
b. Install the midplane drive cage.
5. Install the access panel.
6. Install the server into the rack.
7. Connect all peripheral cables to the server.
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power up the server .
11. If removed, install the front bezel.
Processor replacementProcessor replacement
SubtopicsSubtopics
Processor cautionsProcessor cautions
Removing the processorRemoving the processor
Installing the processorInstalling the processor
Processor cautionsProcessor cautions
CAUTION:CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
To Next Page
Loading...
