4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
7. Use a plastic spudger to pry one side of the blank from the chassis.
ResultsResults
To replace the component, reverse the removal procedure.
Flexible Slot power supply replacementFlexible Slot power supply replacement
Depending on the configuration and the regional location where the server was purchased, the server can be configured with one of the
supported Power supply specifications.
To Next Page
Loading...
