10. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
11. Remove the expansion card.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a type-o storage controllerRemoving and replacing a type-o storage controller
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
To Next Page
Loading...
