ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the LFF drive box 1 blankRemoving and replacing the LFF drive box 1 blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
