HPE ProLiant DL345 Gen11 - Results; Optical drive replacement; Removing and replacing the optical drive from the LFF chassis; Prerequisites

ResultsResults
To replace the component, reverse the removal procedure.
Optical drive replacementOptical drive replacement
SubtopicsSubtopics
Removing and replacing the optical drive from the LFF chassisRemoving and replacing the optical drive from the LFF chassis
Removing and replacing the optical drive from the SFF chassisRemoving and replacing the optical drive from the SFF chassis
Removing and replacing the optical drive from the LFF chassisRemoving and replacing the optical drive from the LFF chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 152