Riser board replacementRiser board replacement
Optical drive replacementOptical drive replacement
Drive backplane replacementDrive backplane replacement
Removing and replacing the OCP NIC 3.0 adapterRemoving and replacing the OCP NIC 3.0 adapter
Removing and replacing the chassis intrusion detection switchRemoving and replacing the chassis intrusion detection switch
Removing and replacing the internal USB deviceRemoving and replacing the internal USB device
Removing the boot device security cover from the NS204i-u + secondary low-profile riser cageRemoving the boot device security cover from the NS204i-u + secondary low-profile riser cage
HPE NS204i Boot Device replacementHPE NS204i Boot Device replacement
Heatsink replacementHeatsink replacement
Processor replacementProcessor replacement
System board assembly replacementSystem board assembly replacement
System battery replacementSystem battery replacement
Safety considerationsSafety considerations
Before performing service procedures, review all the safety information.
Electrostatic discharge
Symbols on equipment
Rack warnings and cautions
Server warnings and cautions
SubtopicsSubtopics
Electrostatic dischargeElectrostatic discharge
Symbols on equipmentSymbols on equipment
Rack warnings and cautionsRack warnings and cautions
Server warnings and cautionsServer warnings and cautions
Electrostatic dischargeElectrostatic discharge
Be aware of the precautions you must follow when setting up the system or handling components. A discharge of static electricity from a
finger or other conductor may damage system boards or other static-sensitive devices. This type of damage may reduce the life expectancy
of the system or component.
To prevent electrostatic damage:
Avoid hand contact by transporting and storing products in static-safe containers.
Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.
Place parts on a grounded surface before removing them from their containers.
Avoid touching pins, leads, or circuitry.
To Next Page
Loading...
