5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Remove the fan cage.
9. Remove the midwall bracket.
10. Remove the drive backplane bracket .
11. Disconnect the SATA-power Y-cable from the optical drive .
12. Disconnect the DisplayPort cable from the system board .
13. Remove the universal media bay:
a. Remove the universal media bay screws (callout 1).
b. Remove the universal media bay from the server (callout 2)
14. Remove the screw (callout 1), and then remove the optical drive from the universal media bay (callout 2).
To Next Page
Loading...
