b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. Remove the fan cage.
10. Remove the midwall bracket.
11. Disconnect all cables from the drive backplane.
12. Remove the E3.S drive cage:
a. Remove the drive cage screws (callout 1).
Retain all screws for future use.
b. Remove the E3.S drive cage from the server (callout 2).
13. Remove the E3.S drive backplane:
a. Remove the backplane screws (callout 1).
Retain all screws. These screws will be used to install the new spare drive backplane.
b. Remove the backplane from the drive cage (callout 2).
To Next Page
Loading...
