4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. Remove the fan cage.
10. Remove the midwall bracket.
11. Remove the drive backplane bracket .
12. Disconnect the cables from the 2 SFF side-by-side drive backplane.
13. Remove the front 2 SFF side-by-side drive cage:
a. Remove the drive cage screws (callout 1).
b. Remove the front 2 SFF side-by-side drive cage from the server (callout 2).
To Next Page
Loading...
