4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. If replacing the boot device carrier on the NS204i-u + secondary low-profile riser cage:
a. Do one of the following:
Remove the air baffle.
Remove the midplane drive cage .
b. Remove the rear 4 LFF drive cage .
c. Remove the NS204i-u + secondary low-profile riser cage .
10. Remove the boot device security cover:
On the boot device riser cage
To Next Page
Loading...
