3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. If the server is in the rear 4 LFF drive configuration, remove the rear 4 LFF drive cage .
10. Remove the secondary riser cage.
11. Remove the serial port blank.
To Next Page
Loading...
