• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1. Observe the following alert.
CAUTION:
To prevent damage to the server or expansion boards, power down the server and remove all
AC power cords before removing or installing the PCI riser cage.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the rear wall blanks.
100 Hardware options installation
To Next Page
Loading...
