When fully inserted, you will feel the carrier frame engage into the rail frame.
e. Remove the pin field cover cap.
f. Close the processor rail frame and tighten the captive screws until they stop.
The installation is complete.
HPE Trusted Platform Module 2.0 Gen10 option
Overview
Use these instructions to install and enable an HPE TPM 2.0 Gen10 Kit in a supported server. This option
is not supported on Gen9 and earlier servers.
This procedure includes three sections:
1. Installing the Trusted Platform Module board.
2. Enabling the Trusted Platform Module.
3. Retaining the recovery key/password.
HPE TPM 2.0 installation is supported with specific operating system support such as Microsoft
®
Windows Server
®
2012 R2 and later. For more information about operating system support, see the
product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs). For more
HPE Trusted Platform Module 2.0 Gen10 option 127
To Next Page
Loading...
