10. Connect the SID module cable to the front power/USB 3.0 connector.
11. Install the fan cage.
12. Install the air baffle.
13. Install the access panel.
14. Slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
The installation is complete.
Installing a FlexibleLOM adapter
Prerequisites
• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Power down the server .
2. Do one of the following:
• Disconnect each power cord from the power source.
• Disconnect each power cord from the server.
3. Do one of the following:
Installing a FlexibleLOM adapter 121
To Next Page
Loading...
