9. Connect the power cable.
10. Install a storage controller.
11. Connect the data cables from the drive backplane to the controller.
12. Install drives or drive blanks.
The installation is complete.
Installing airflow labels
When an Express Bay drive cage is installed, airflow labels might be required:
Prerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
Procedure
• If an eight-bay SFF drive cage is installed in box 1, then airflow labels are not required.
• If a blank is installed in box 1, replace it with the blank that comes with the kit.
Installing airflow labels 77
To Next Page
Loading...
