HPE ProLiant DL385 Gen10 - Cabling; HPE Proliant Gen10 DL Servers Storage Cabling Guidelines; Cabling Diagrams

Cabling
HPE ProLiant Gen10 DL Servers Storage Cabling
Guidelines
When installing cables, observe the following:
• All ports are labeled:
◦ System board ports
◦ Controller ports
◦ 12G SAS Expander ports
• Most data cables have labels near each connector with destination port information.
• Some data cables are pre-bent. Do not unbend or manipulate the cables.
• Before connecting a cable to a port, lay the cable in place to verify the length of the cable.
• When routing cables from the front to the rear of the server, use the cable channels on either side of
the chassis.
Cabling diagrams
Use the following tables to find cabling information and diagrams.
Table 1: SAS/SATA kits
Option kit Cable part
number
From To Power cable part
number
Front 2SFF SAS side by side
(LFF)
882066-001
1
Drive
backplane
System board
869810-001
7
Front 2SFF SAS/SATA drive cage
(SFF)
869826-001
2
Drive
backplane
• System
board
• SAS
Expander
• Controller
869810-001
7
869825-001
7
Table Continued
134 Cabling