HPE ProLiant DL385 Gen10 - Installing a Front 8 SFF SAS;SATA Drive Cage in Box 1

Installing a front 8SFF SAS/SATA drive cage in box 1
Prerequisites
Before installing this option, be sure that you have the following:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack .
4. Remove the access panel.
5. Remove the air baffle.
6. Remove the fan cage.
7. Remove the bay blank.
Installing a front 8SFF SAS/SATA drive cage in box 1 79