Installing a processor
Observe the following:
• Before performing this procedure, HPE recommends identifying the processor-heatsink module
components.
• Intelligent System Tuning supports specific processors and configurations. For more information, see
the product QuickSpecs on the Hewlett Packard Enterprise website.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• T-20 Torx screwdriver
Procedure
1. Observe the following alerts.
CAUTION:
When handling the heatsink, always hold it along the top and bottom of the fins. Holding it from
the sides can damage the fins.
CAUTION:
To avoid damage to the processor or system board, only authorized personnel should attempt to
replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION:
If installing a processor with a faster speed, update the system ROM before installing the
processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise
Support Center website.
CAUTION:
THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the
socket or processor, do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Installing a processor 125
To Next Page
Loading...
