hpmont HD3N Series - Page 141

Appendix A Parameters Shenzhen Hpmont Technology Co., Ltd.
- 122 - HD3N Series User Manual V1.1
Ref. Code
Function Setting Range Default Unit Attribute Setting
F06.18 Phase 1 running time 0.0 - 3276.7 5.0 0.1
○
F06.20 Phase 2 running time 0.0 - 3276.7 0.0 0.1
○
F06.22 Phase 3 running time 0.0 - 3276.7 0.0 0.1
○
F06.24 Phase 4 running time 0.0 - 3276.7 0.0 0.1
○
F06.26 Phase 5 running time 0.0 - 3276.7 0.0 0.1
○
F06.28 Phase 6 running time 0.0 - 3276.7 0.0 0.1
○
F06.30 Phase 7 running time 0.0 - 3276.7 0.0 0.1
○
F06.32 Phase 8 running time 0.0 - 3276.7 0.0 0.1
○
F06.34 Phase 9 running time 0.0 - 3276.7 0.0 0.1
○
F06.36 Phase 10 running time 0.0 - 3276.7 0.0 0.1
○
F06.38 Phase 12 running time 0.0 - 3276.7 0.0 0.1
○
F06.40 Phase 12 running time 0.0 - 3276.7 0.0 0.1
○
F06.42 Phase 13 running time 0.0 - 3276.7 0.0 0.1
○
F06.44 Phase 14 running time 0.0 - 3276.7 0.0 0.1
○
F06.46 Phase 15 running time 0.0 - 3276.7 0.0 0.1
○
F07: Wobble Function Parameter (on pages66 - 67)
F07.00 Wobble function selection
0: Disable
1: Enable
0 1
×
F07.01 Wobble running mode
Unit: Entry way
0: Auto entry (refer to F07.03)
1: Manually terminal entry way
Ten: Wobble control (refer to 07.04)
0: Relate to wobble centric frequency
1: Relate to max. Output frequency
Hundred: Start when HD3N stops
during wobbling
0: Start according to memory before
it stops
1: Restart
Ten thousand: Save selection at
power failure
0: Save wobble state at power failure
1: Do not wobble state at power
failure
0000 1
×
F07.02 Wobble preset frequency 0.00 - upper limit frequency 0.00Hz 0.01Hz
×
F07.03
Waiting time for wobble
preset frequency
0.0 - 999.9s 0.0s 0.1s
×
F07.04 Wobble value 0.0 - 50.0% 0.0% 0.1%
×
F07.05 Skip frequency 0.0% - F07.04 0.0% 0.1%
×
F07.06 Wobble period 0.1 - 999.9s 10.0s 0.1s
×