Huawei AR3200 Series - Page 113

Networking Requirements
An enterprise requires departments in charge of the same service to communicate with each
other while isolating departments in charge of different services.
As shown in Figure 3-2, an enterprise has four departments. Department 1 is connected to
RouterA, which is connected to Ethernet 2/0/1 of the Router. Department 2 is connected to
RouterB, which is connected to Ethernet 2/0/2 of the Router. Department 3 is connected to
RouterC, which is connected to Ethernet 2/0/3 of the Router. Department 4 is connected to
RouterD, which is connected to Ethernet 2/0/4 of the Router. The requirements are as follows:
l Department 1 and Department 2 in VLAN 2 are isolated from Department 3 and Department
4 in VLAN 3.
l Department 1 and Department 2 in VLAN 2 can communicate with each other.
l Department 3 and Department 4 in VLAN 3 can communicate with each other.
Figure 3-2 Network diagram of interface-based VLAN assignment
Eth2/0/1
RouterA
Eth2/0/2 Eth2/0/3
Eth2/0/4
Department 1
VLAN2 VLAN3
RouterB RouterC
RouterD
Router
Department 2 Department 3 Department 4
Configuration Roadmap
The configuration roadmap is as follows:
1. Create VLANs.
2. Add interfaces to the VLAN.
Data Preparation
To complete the configuration, you need the following data:
l Ethernet 2/0/1 and Ethernet 2/0/2 belong to VLAN 2.
l Ethernet 2/0/3 and Ethernet 2/0/4 belong to VLAN 3.
Procedure
Step 1 Configure the Router.
# Create VLAN 2.
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 3 VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
102