Huawei AR3200 Series - Page 148

Figure 4-3 Networking diagram of a voice VLAN in manual mode
Router
HG
Internet
DHCP Server
HSI VoIP IPTV
Eth2/0/1
GE3/0/0
Configuration Roadmap
The configuration roadmap is as follows:
1. Create VLANs and VLANIF interfaces on the Router and configure interfaces so that
enterprise users can access the WAN through the Router.
2. Enable the voice VLAN function on Ethernet2/0/1 and configure the voice VLAN.
3. Configure a traffic policy and apply it to the inbound interface of voice data packets.
Data Preparation
To complete the configuration, you need the following data:
l ID of the voice VLAN: VLAN 2
l ID of the VLAN that the IP phone uses to request an IP address: VLAN 6
l IP address of the VLANIF interface corresponding to the voice VLAN: 192.168.2.1/24
l OUI and mask of the voice VLAN: 0011-2200-0000 and ffff-ff00-0000
l Default VLAN of Ethernet2/0/1: VLAN 6
l IP address of the WAN-side interface: 192.168.4.1/24
l Re-marked DSCP priority for voice data packets with the source MAC address
0011-2200-0000 or VLAN ID 2: 46
l Type and number of the interface and direction to which the traffic policy is applied:
inbound direction of Ethernet2/0/1 on the Router
Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN 4 Voice VLAN Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
137