NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)
Copyright © Huawei Technologies Co., Ltd.
When moving the equipment, do not use any part of the equipment to support it. This
may damage the equipment.
Use a pallet truck to unload the equipment and its case from the vehicle. The forks must
be properly positioned to ensure that the equipment does not fall over. Secure the
equipment to the pallet truck before moving it, and assign personnel to watch the
equipment during movement.
Move the equipment close to the installation site before unpacking. Unpack the
equipment with caution to avoid scratching or bumping it. Unload the equipment from
the pallet immediately before installation.
Figure 1-1 Transportation gradient
Welding Hazard
At least two persons are required at the welding site.
The welder must have the required licenses for welding.
No flammable materials are allowed in the welding area.
Ensure that fire extinguisher, wet cloth, and water container are available.
Do not place a flaming welding torch on equipment or the ground. To avoid burning
caused by gas leaks, do not put an acetylene and oxygen welding torch inside a metal
container.
Cool down hot pipes immediately after welding them.
Do not weld or cut on pressurized containers or pipes. Disconnect the equipment from
power sources before welding or cutting.
1.4 Operating Safety
High Temperature and High Pressure
Incorrect operations may cause excessive pressure, which may result in breakage or
exploration of the cooling system.
To Next Page
