NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)
Copyright © Huawei Technologies Co., Ltd.
High-temperature components: compressor, refrigerant pipe, and electric heater.
High-pressure components: compressor and refrigerant pipe.
Refrigerant Hazard
To avoid frostbite caused by refrigerant leaks, take protective measures such as wearing
antifreeze gloves when handling refrigerant.
Low-temperature component: evaporator.
High Rotational Speed
High-speed rotating component: fan.
1.5 Others
Binding Signal Cables
Signal cables must be bound separately from power cables with a spacing of at least 50 mm.
Laying Out Cables
In very low temperatures, violent impacts or vibration may crack the plastic cable jacket. To
ensure safety, comply with the following requirements:
Cables must be laid out and installed only when the temperature is higher than 0°C.
Cables previously stored at subzero temperatures must be stored at room temperature for
at least 24 hours before they are laid out.
Handle cables with caution, especially at a low temperature. Do not drop cables from
vehicles to the ground.
Cables must be routed with a distance of at least 30 mm between the cables and the DC
busbar, shunt, and fuse. This prevents damage to and decelerates deterioration of the
insulation layer of the cables. Cables must be flame-retardant and must not be routed
behind the air inlets or outlets of the cabinet. The air inlets and outlets must not be
blocked.
Storage
Ensure that the equipment is not located near heat sources or directly exposed to
sunlight.
To avoid explosion or refrigerant leaks, keep sources of ignition and high-temperature
objects far away from the equipment. This is especially important for equipment
containing high-pressure nitrogen or refrigerant.
To Next Page
Loading...
Need help?
General
