Huawei SmartAX MT800 ADSL CPE - Chapter 1 Basic Information; 1.1 System Requirements

User Manual
SmartAX MT800 ADSL CPE
Chapter 1 Basic Information
1-1
Chapter 1 Basic Information
This user manual provides instructions on how to install the
MT800 ADSL CPE and use it to connect a computer or Ethernet LAN
to the Internet.
1.1 System Requirements
To install and manage the MT800 you need a computer
equipped with an Ethernet network interface card (NIC) and a Web
browser. You may also need to use information given to you by your
ISP or ADSL service provider.
1.1.1 Operating System
The MT800 uses an HTML-based Web interface for setup and
management. The computer for configuration requires an operating
system capable of running Web browser software.
1.1.2 Web Browser
Any common Web browser can be used to configure the MT800.
The program is designed to work best with more recently released
browsers such as Microsoft Internet Explorer® version 5.0,
Netscape Navigator® version 4.7, or later versions. The Web
browser must have JavaScript enabled. Make sure JavaScript has
not been disabled by other software (such as virus protection or Web
user security packages) that may be running on your computer.