User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-9
Step 11. Set DNS Relay as disable at DNS page and click
submit button under the field to submit the setting to the ADSL CPE.
Besides, you should set DNS server information provided by ISP at
his computer.
Step 12. Click and select the Save & Reboot page, select the
option Save and then click submit to finish the setting of ADSL and
save it permanently.
5.2.6 RFC 24684 Route (IPoA) Configuration
Step 1. Open the web page ATM Setting.
Step 2. Select the option RFC2684 Route (IPoA) in
Connection Type.
Step 3. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 4. Select option IPoA in Application.
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of VPI, VCI, IP Address, Subnet Mask, and Gateway IP
address; Set Operation Mode and Default Route as Enabled.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting to ADSL terminal.
Step 7. Leave the ADSL Mode as default value. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
To Next Page
Loading...
