User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-13
Figure 4-9 LAN Configuration
To change the LAN IP address, click the Refresh button and
type in the new settings as described below.
LAN IP Address
Type in the IP address for the Ethernet LAN interface.
Default = 192.168.1.1
Note: the public IP address that ISP assigned is not LAN
IP address. The public IP address identifies the WAN
interface that the ADSL terminal connects to Internet.
LAN Network Mask
Type in the Subnet Mask for the Ethernet LAN IP
interface. Default = 255.255.255.0
Note:
If you are changing the IP address you will need to login again to access the web
manager.
4.6 DHCP Mode Configuration
Click the DHCP Mode of Other Setting in the Wizard Column
to set the DHCP mode. DHCP services that provided by MT800
To Next Page
Loading...
