User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-2
5.2 Service Types and Configuring Illustration
5.2.1 PPPoE Configuration
Step 1. Open the web page ATM Setting.
Step 2. Select the option PPP in Connection Type.
Step 3. Select the option PPPoE in PPPoA/PPPoE.
Step 4. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of VPI, VCI, PAP or CHAP, User name, Password. Set
Operation Mode and Default Route as Enabled.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting to ADSL terminal.
Step 7. Leave the ADSL Mode as default setting. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
Step 8. Leave the LAN IP Address as the default values
192.168.1.1, and Subnet Mask as 255.255.255.0. If you want to
modify the configuration of LAN IP, please follow the detail setting
procedure in Section 4.5 LAN Configuration.
Step 9. Usually to leave the NAT Mode as default setting
Enable. For more detailed settings, please refer to the Section 4.8
NAT Configuration.
To Next Page
Loading...
