Huawei SmartAX MT800 ADSL CPE - 4.3.2 RFC2684 Route (IPoA) Configuration

User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-9
4.3.2 RFC2684 Route (IPoA) Configuration
z
PVC:
The system provides 8 PVCs. Generally you can
leave this set at the default value 0. This option is also used
to create and configure new PVCs.
z
VPI:
If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default values of PVCs.
z
VCI:
If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default values of PVCs.
z
Operation Mode:
This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
z
Encapsulation:
You can select the mode LLC or VC MUX.
z
IP Address
and
Subnet Mask:
Enter the IP address and
subnet mask provided by ISP for the WAN interface of your
MT800.
z
Default Route:
This setting specified the IP address
above is using for default route of LAN. The data will be
sent through WAN interface whenever a client LAN
computer accesses the Internet.
You should enter the IP address provided by your ISP. The
default setting of route is Disable, and the Gateway IP address is
0.0.0.0. The recommended setting is to enable default route and
enter the Gateway IP address provided by your ISP.