Huawei SmartAX MT800 ADSL CPE - 4.3.3 PPP Configuration

User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-10
Figure 4-6 RFC2684 Route (IPoA) Configuration
4.3.3 PPP Configuration
There are two options for PPP configuration: PPPoA and
PPPoE. The parameters that need to be configured are described as
below:
z
PVC: The system provides 8 PVCs. Generally you can
leave this set at the default value 0. This option is also
used to create and configure new PVCs.
z
VPI: If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default value of PVC.
z
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.