User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-6
5.2.4 RFC 2684 Bridged (Static IP) Configuration
Step 1. Open the web page ATM Setting
Step 2. Select the option RFC2684 Bridged in Connection
Type.
Step 3. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 4. Select option Static IP in Application.
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of PVC, VPI, VCI, IP Address, Subnet Mask, Gateway IP
Address and DNS. Set Operation Mode and Default Route as
Enabled.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting into ADSL terminal.
Step 7. Leave the ADSL Mode as default value. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
Step 8. Leave the LAN IP Address as the default value
192.168.1.1, and the Subnet Mask as 255.255.255.0. If you want to
modify the configuration of LAN IP, please follow the detail setting
procedure in Section 4.5 LAN Configuration.
Step 9. Usually to leave the NAT Mode as default setting
Enable. For more detailed settings, please refer to the Section 4.9
NAT Configuration.
To Next Page
Loading...
