User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-5
Step 2. Select the option RFC 2684 Bridged in Connection
Type.
Step 3. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 4. Select option Pure Bridge in Application.
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of VPI and VCI.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting to ADSL terminal.
Step 7. Leave the ADSL Mode as default value. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
Step 8. Leave the LAN IP Address as the default value
192.168.1.1, and the Subnet Mask as 255.255.255.0. If you want to
modify the configuration of LAN IP, please follow the detailed setting
procedures in Section 4.5 LAN Configuration.
Step 9. The default setting of DHCP is None. You needs to
install a PPPoE dial-up software and configure the IP setting of
computer in the LAN as to obtain an IP address automatically.
Step 10. Click and select the Save & Reboot page, select the
option Save and then click submit to finish the setting of ADSL and
save it permanently.
To Next Page
Loading...
