User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-21
alternative routes, the one with the lowest hop count is
considered the fastest path.
4) Select Send Mode and Receive Mode.
z
The Send Mode setting indicates the RIP version this
interface will use when it sends its route information to
other devices.
z
The Receive Mode setting indicates the RIP version(s) in
which information must be passed to the MT800 in order
for it to be accepted into its routing table.
5) Click the Add button. The new RIP entry will display in the
table.
6) Click the Enable radio button to enable the RIP feature.
Note:
RIP version 1 is the original RIP protocol. Select RIP1 if you have devices that
communicate with this interface that understand RIP version 1 only.
RIP version 2 is the preferred selection because it supports "classless" IP
addresses (which are used to create subnets) and other features. Select RIP2 if all
other routing devices on your LAN support this version of the protocol.
4.11 Firewall Configuration
4.11.1 Configuration of Global Firewall
The Firewall enables you to protect the system against denial of
service (DoS) attacks and other types of malicious accesses to your
To Next Page
Loading...
