User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-7
Step 10. The default setting of DHCP is None. You should
configure the PC’s IP address as the same subnet with the LAN IP of
MT800. If you need to configure the MT800 as DHCP Server mode,
please select DHCP Server option. You should configure the IP
setting of computer in the LAN as to obtain an IP address
automatically. If you need to configure the mode as DHCP Relay,
please select DHCP Relay option, and enter the DHCP Server
address that provided by ISP. At the same time, you should configure
the IP setting of computer in the LAN as to obtain an IP address
automatically. In the case of DHCP Relay, you should disable NAT
function.
Step 11. Set DNS Relay as disable at DNS page and click
submit button under the field to submit the setting to the ADSL CPE.
Besides, you should set DNS server information provided by ISP at
his computer.
Step 12. Click and select the Save & Reboot page, select the
option Save and then click submit to finish the setting of ADSL and
save it permanently.
5.2.5 RFC 2684 Bridged (DHCP) Configuration
Step 1. Open the web page ATM Setting.
Step 2. Select the option RFC2684 Bridged in Connection
Type.
Step 3. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 4. Select option DHCP in Application.
To Next Page
Loading...
