User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-3
Step 10. The default setting of DHCP is None. You should
configure the PC’s IP address as the same subnet with the LAN IP of
MT800. If you need to configure the MT800 as DHCP Server mode,
please select DHCP Server option. You should configure the IP
setting of computer in the LAN as to obtain an IP address
automatically. If you need to configure the mode as DHCP Relay,
please select DHCP Relay option, and enter the DHCP Server
address that provided by ISP. At the same time, you should configure
the IP setting of computer in the LAN as to obtain an IP address
automatically.
Step 11. Click and select the Save & Reboot page, select the
option Save and then click submit to finish the setting of ADSL and
save it permanently.
5.2.2 PPPoA Configuration
Step 1. Open the web page ATM Setting.
Step 2. Select the option PPP in Connection Type.
Step 3. Select the option PPPoA in PPPoA/PPPoE.
Step 4. Select option LLC or VC MUX in Encapsulation
according to the directions from your ISP or system provider.
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of VPI, VCI, PAP or CHAP, User name, Password. Set
Operation Mode and Default Route as Enabled.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting to ADSL terminal.
To Next Page
Loading...
