User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-4
Step 7. Leave the ADSL Mode as default setting. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
Step 8. Leave the LAN IP Address as the default value
192.168.1.1, and the Subnet Mask as 255.255.255.0. If you want to
modify the configuration of LAN IP, please follow the detail setting
procedure in Section 4.5 LAN Configuration.
Step 9. Usually to leave the NAT Mode as default setting
Enable. For more detailed settings, please refer to the Section 4.9
NAT Configuration.
Step 10. The default setting of DHCP is None. You should
configure the PC’s IP address as the same subnet with the LAN IP of
MT800. If you need to configure the MT800 as DHCP Server mode,
please select DHCP Server option. You should configure the IP
setting of computer in the LAN as to obtain an IP address
automatically. If you need to configure the mode as DHCP Relay,
please select DHCP Relay option, and enter the DHCP Server
address that provided by ISP. At the same time, you should configure
the IP setting of computer in the LAN as to obtain an IP address
automatically.
Step 11. Click and select the Save & Reboot page, select the
option Save and then click submit to finish the setting of ADSL and
save it permanently.
5.2.3 RFC 2684 Bridged (Pure Bridge) Configuration
Step 1. Open the web page ATM Setting.
To Next Page
Loading...
