User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-38
The diagnostics utility will run a series of test to check whether
the device's connections are up and working. This takes only a few
seconds. The program reports whether the test passed or failed. A
test may be skipped if the program determines that no suitable
interface is configured on which to run the test.
4.15 Access Management
The first time you log into the Web Configuration Manager, use
the default user ID and password (admin and admin). For the default
user ID, admin, only the password can be changed. The method to
change the password of admin or users described as below:
Perform the following steps to change the password:
1) Open the Access Management page;
2) Enter the configuration page User Config-Modify by click
the
in the operation column;
3) Enter the new password, confirm the password and
submit;
4) Save the setting in the Save&Restart page and then
restart the system to take effect the setting.
To Next Page
Loading...
