User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-12
4.4 ADSL Mode Configuration
Click the ADSL Mode of Others Setting in the Wizard column
to set the ADSL mode. Usually the ADSL mode is set to the default
value Multimode, and need not to be changed. If your ISP instructs
you to change your ADSL settings, choose the appropriate ADSL
mode in this web page.
Figure 4-8
ADSL Mode Configuration
4.5 LAN Configuration
Click the LAN Configuration of Other Setting in the Wizard
Column to set the LAN interface. The LAN IP address identifies the
LAN port (eth-0) as a node on your network; that is, its LAN IP
address must be in the same subnet as the computers on your LAN.
You can change the default LAN IP address and Net Mask to
suit for your LAN.
To Next Page
Loading...
