User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-19
Local Address From
Type the starting IP of the range of private address you want
to be translated. You can specify that data from all LAN
addresses should be translated by typing 0 (zero) in each
From field and 255 in each To field. Or, type the same
address in both fields if the rule only applies to one LAN
computer.
Local Address To
Type the ending IP of the range of private address you want
to be translated.
Local Address Type the private IP address you want to be translated.
Destination Port From
Enter the starting port ID (or a range) that you expect to see
on incoming packets destined for the LAN computer for
which this rule is being created.
With the ending port ID (or a range) specified in the next
field, incoming traffic that meets these criteria will be
redirected to the Local Port number you specified.
Destination Port To Enter the ending port ID (or a range).
4.10 RIP Configuration
RIP is an Internet protocol. You can set up to share routing table
information with other routing devices on your LAN, at your ISP's
location, or on remote networks connected to your network via the
ADSL line.
Click the RIP of Advanced Functions in the Wizard Column to
set the RIP.
To Next Page
Loading...
