User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-18
Figure 4-14 Add NAT Rule
From the Rule Flavor drop-down list, select REDIRECT, DMZ,
and NAPT. The page redisplays with only the fields that are
appropriate for the chosen NAT flavor.
The information in the various pages is summarized in the table
below.
Rule ID
The Rule ID determines the order in which rules are invoked
(the lowest numbered rule is invoked first, and so on). In
some cases, two or more rules may be defined to act on the
same set of IP addresses. Be sure to assign the Rule ID so
that the higher priority rules are invoked before lower-priority
rules. It is recommended that you select rule IDs as multiples
of 5 or 10 so that, in the future, you can insert a rule between
two existing rules.
IF Name Displays the name of the interface.
Protocol
This selection specifies which type of Internet
communication will be subject to this translation rule. You
can select TCP or UDP.
To Next Page
Loading...
