User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-35
No: The rule will be applied only to packets that do not
contain header options.
Ignore: (Default) The rule will be applied to packets
whether or not they contain header options, assuming
that they match the other criteria.
z
Packet Size: Specifies that the IP Filter rule will take affect
only on packets whose size in bytes matches this criterion.
(lt = less than, gt = greater than, lteq = less than or equal to,
etc.)
z
TOD Rule Status: The Time of Day Rule Status
determines how the Start Time/End Time settings are
used.
z
Enable: (Default) The rule is in effect for the specified time
period.
z
Disable: The rule is not in effect for the specified time
period, but is effective at all other times.
When you are done selecting criteria, ensure that the Enable
radio button is selected at the top of the page, and then click the
Submit button at the bottom of the page. After a confirmation page
displays, the IP Filter -Configuration page will redisplay with the new
rule showing in the table.
Ensure that the Security Level and Private/Public Default Action
settings on the IP Filter Configuration page are configured as needed,
and then click the Submit button. A page displays to confirm your
changes.
To Next Page
Loading...
